Go back

SAV 244.43
Round electro-magnets with parallel pole pitch P = 4 mm

Do you have questions?

The data sent will be processed only for the purpose of processing your request. Further information can be found in our privacy policy.


For grinding of thin and plate-shaped workpieces.

  •   Grinding of thin plates, wide rings with less thickness and minimum width of 40 mm
  • For workpieces up to minimum thickness of 2 mm
  • For flat workpieces, minimum 40 x 40 mm²
  • Pole plate with exceptionally narrow, uniform pole pitch, 3 mm steel and 1 mm Ms
  • Low installation height
  • Glued discs and reinforced with tie rods
  • High accuracy due to pole plate screw joint in the narrow grid
  • Low field height with 4 mm
  • Switch-off via demagnetisation cycle
  • Fixing hole pattern with threads on the rear side and/or through holes as per agreement
  • 8 mm wearing capacity of the pole surface
  • Robust and water-tight
  • Protection type IP 65
  • Suitable for connection with control device SAV 876.10
Order example:

Round electro-magnet clamping plate SAV 244.43 - 300 - 110 V
Denomination SAV - No. - A - voltage

Order example of controller:
Electronic pole-reversal control device SAV 876.10 - S-O-110/6/230
Manual operating unit SAV 876.02 - SE3
Denomination SAV - No.

Technical specifications:

Nominal adhesion force:
100 N/sqcm, can be controlled by the control device using the adhesion force coding switch

Rated voltage, recommended:
110 V DC