SAV 878.05

For remainder residual magnetisation measurements at workpieces and tools, in drilled holes and gaps.

SAV 890.42

An interfering residual magnetism can remain in steel and cast workpieces after machining. If these parts have to be demagnetised for other purposes, this can usually be easily achieved with the tunnel demagnetisers.

SAV 890.43

For automatic demagnetising on the production line with continuous plastic transport belt and drive motor. The workpieces are moved through the tunnel with a speed of approx. 0.2 m/s. A low-frequency generator can be used as a ballast unit for parts which are difficult to demagnetise.

SAV 890.70

For demagnetising the surfaces of larger workpieces. Mobile use.

SAV 890.71

For demagnetising workpieces, tools, dies, milling heads, etc.

SAV 486.04

For detecting remanence on workpieces and tools as a pole indicator.

SAV 486.40

The required pressure can be generated by turning the screw clockwise with an Allen key.

SAV 245.01

Angles are determined using the end dimensions according to the sine principle. A laterally installed fixing shear and the upper bearing shell halves are used for clamping.

SAV 245.02

Angles are determined using the end dimensions according to the sine principle. A laterally installed fixing shear and the upper bearing shells are used for clamping.

SAV 245.03

Angles are determined using the end dimensions according to the sine principle. A laterally installed fixing shear and the upper bearing shell halves are used for clamping.

SAV 245.04

Angles are determined using the end dimensions according to the sine principle. A laterally installed fixing shear and the upper bearing shell halves are used for clamping.

SAV 245.05

Angles are determined using the end dimensions according to the sine principle. A laterally installed fixing shear and the upper bearing shell halves are used for clamping.

SAV 245.06

For grinding and measuring precision workpieces in each angle position without rechucking the parts.

SAV 245.07

Die Winkel werden mit Hilfe der Endmaße nach dem Sinusprinzip bestimmt. Die Klemmung erfolgt über eine seitlich angebrachte Befestigungsschere und die oberen Lagerschalen.

SAV 245.09

Angles are determined using the end dimensions according to the sine principle.

SAV 245.10

Angles are determined using the end dimensions according to the sine principle.

SAV 245.40

Angles are determined using the end dimensions according to the sine principle. The controllable magnet block is removable and can thus also be used without the sine table.

SAV 245.41

Angles are determined using the end dimensions according to the sine principle. The controllable magnet block is removable and can thus also be used without the sine table.

SAV 241.29

Due to the extremely low height, these chucks are primarily used in handling applications. The magnet is active when switched on and is used for holding ferromagnetic workpieces. To achieve the rated holding force, the steel surfaces of the contact side must be fully covered by the workpiece.

SAV 241.31

Clamping electro-magnets allow holding of ferromagnetic workpieces.