SAV 241.31

Clamping electro-magnets allow holding of ferromagnetic workpieces.

SAV 241.32

Type C devices are suitable for holding parts with flat surfaces, while type D devices can be used for parts with uneven or scaled surfaces. To achieve the rated holding force, the steel surfaces of the contact side must be fully covered by the workpiece.

SAV 241.40

Because the permanent electro magnetic workholding system is active when the device is de-energised, these chucks are preferably used where long holding times are required and no holding force is required only for short periods or occasionally. They are also used as safety magnets in transport systems and lifting gear, as the load is reliably held during a power failure. To achieve the rated holding force, the steel surfaces of the contact side must be fully covered by the workpiece.

SAV 241.41

Because the permanent electro magnetic workholding system is active when the device is de-energised, these chucks are preferably used where long holding times are required and no holding force is required only for short periods or occasionally. They are also used as safety magnets in transport systems and lifting gear, as the load is reliably held during a power failure. To achieve the rated holding force, the steel surfaces of the contact side must be fully covered by the workpiece.

SAV 248.02

As a support plate for magnets with transverse pole pitch. Can be used only in combination with the magnetic clamping plate with the disc progression
in the same direction.

SAV 248.03

For placing on magnetic clamping plates in case of the disc progression in the same direction in order to induce the magnetic field in the workpiece.

SAV 248.40

For safe clamping of non-magnetic materials on magnets.

SAV 248.60

Alaminated blocks for placing on magnetic chucks with parallel pole pitch

SAV 248.61

In conjunction with magnetic chucks for machining irregular workpieces.

SAV 242.01

For profiling and machining small workpieces, e.g. dies. For chucking thin parts, we recommend chuck MH 204 with extra-fine pole pitch.

SAV 242.02

For angled and parallel grinding of small and medium workpieces. Suitable as an add-on block for the base magnet on the machine.

SAV 242.07

In conjunction with magnetic chucks for grinding workpieces with protruding sections, narrow sides, gauges, etc.

SAV 242.11

For angled and parallel grinding of small and medium workpieces.

SAV 242.05

For workpieces which are difficult to chuck, e.g. Ferro-Tic, tungsten carbide with cobalt content, very small workpieces. For fast and easy chucking – also for workpieces with complicated EDM contours or workpieces which are difficult to chuck.

SAV 243.15

Als Spannmittel zum Festhalten von Werkstücken auf Erodiermaschinen und Werzeugmaschinen, für Vorrichtungen etc.

SAV 242.21

4 magnetic contact surfaces (top and bottom and 2 face sides) which are switched on and off together.

SAV 242.22

2 magnetic contact surfaces which are switched on and off together (large prism and opposite prism). Available individually (S) and in pairs (P).

SAV 242.25

2 magnetic contact surfaces which are switched on and off together (large prism and opposite prism).

SAV 242.29

3 magnetic contact surfaces (top surface with prism and 2 faces). Including removable key. Strong, switchable permanent magnet. 2 prisms ground together at the same height Fully sealed.

SAV 242.31

4 magnetic adhesion surfaces (top side, bottom side and 2 front surfaces). With 2 opposite switching points including removable socket spanner. Extremely strong, controllable permanent-magnet.